R
Member
A conjugate match that gives S11 = -30 dB at a single spot frequency is not automatically a good design. The loaded Q of the matching network sets how fast the match degrades away from that frequency.
For a simple L-network transforming R_low to R_high, the intermediate node Q is approximately
Q = sqrt(R_high / R_low - 1)
Transforming 50 ohm to 5 ohm gives Q = sqrt(10 - 1) = 3. A rough fractional bandwidth estimate is BW ~ 2/Q for a single-section match, so the usable band is limited. Splitting the transformation into two or three lower-ratio sections reduces Q per section and widens the band, at the cost of extra components and insertion loss.
Practical checks before trusting a simulation:
1) Use the actual source/load impedance including package parasitics, not an ideal 50 ohm. A transistor input is rarely purely resistive.
2) Sweep component tolerance and S-parameter variation. A 0.2 pF spread at 2.4 GHz moves the match noticeably; if the design only works with exact values, it will not survive production.
3) Include PCB pad and via parasitics in the model; at a few GHz a pad can add 0.1-0.3 pF.
4) Look at both S11 and transducer gain. Optimising only return loss can reduce delivered power.
Verification: measure with a VNA after a full calibration at the fixture plane, compare the swept S11 against simulation over temperature, and record the frequency range where S11 stays below the agreed limit rather than quoting the best single point.
Takeaway: report matched bandwidth, component sensitivity and insertion loss together. A deep but narrow notch is often worse for a real radio than a shallower, wider match.
For a simple L-network transforming R_low to R_high, the intermediate node Q is approximately
Q = sqrt(R_high / R_low - 1)
Transforming 50 ohm to 5 ohm gives Q = sqrt(10 - 1) = 3. A rough fractional bandwidth estimate is BW ~ 2/Q for a single-section match, so the usable band is limited. Splitting the transformation into two or three lower-ratio sections reduces Q per section and widens the band, at the cost of extra components and insertion loss.
Practical checks before trusting a simulation:
1) Use the actual source/load impedance including package parasitics, not an ideal 50 ohm. A transistor input is rarely purely resistive.
2) Sweep component tolerance and S-parameter variation. A 0.2 pF spread at 2.4 GHz moves the match noticeably; if the design only works with exact values, it will not survive production.
3) Include PCB pad and via parasitics in the model; at a few GHz a pad can add 0.1-0.3 pF.
4) Look at both S11 and transducer gain. Optimising only return loss can reduce delivered power.
Verification: measure with a VNA after a full calibration at the fixture plane, compare the swept S11 against simulation over temperature, and record the frequency range where S11 stays below the agreed limit rather than quoting the best single point.
Takeaway: report matched bandwidth, component sensitivity and insertion loss together. A deep but narrow notch is often worse for a real radio than a shallower, wider match.
