R
Member
A microstrip patch resonates near L ~ c / (2 f sqrt(eps_eff)), where eps_eff is the effective permittivity of the substrate stack. Higher eps_r shrinks the antenna, which is attractive for compact modules, but it also tends to reduce bandwidth and radiation efficiency because more energy is confined near the dielectric.
The usual design tension:
Thicker, lower-eps_r substrate -> wider impedance bandwidth, better efficiency, but larger patch and more surface-wave excitation
Thinner, higher-eps_r substrate -> smaller size, narrower bandwidth, tighter fabrication tolerance
Practical numbers (verify against the laminate datasheet): a conventional half-wave patch on a standard FR4-type stack often gives only a few percent of -10 dB bandwidth; going to a low-loss, low-eps_r foam or thicker RF laminate can widen that substantially. Feeding technique also matters: a proximity or aperture-coupled feed generally offers more bandwidth than a direct edge feed, at the cost of stack complexity.
Checks before ordering a board:
1) Simulate with the real laminate eps_r and loss tangent at the operating frequency, not the 1 MHz catalogue value.
2) Include the ground plane size, the housing, and nearby components. A patch on a small device ground behaves very differently from one on an infinite ground.
3) Run a tolerance sweep on eps_r and etch width; narrow-band designs can shift out of band with normal laminate variation.
4) Measure S11 and radiation pattern in the final enclosure. A good S11 alone does not guarantee acceptable gain or pattern.
Takeaway: bandwidth is a system property of the stack-up, feed, ground and enclosure. Decide the mechanical envelope first, then choose the laminate and feed that still meet the bandwidth requirement.
The usual design tension:
Thicker, lower-eps_r substrate -> wider impedance bandwidth, better efficiency, but larger patch and more surface-wave excitation
Thinner, higher-eps_r substrate -> smaller size, narrower bandwidth, tighter fabrication tolerance
Practical numbers (verify against the laminate datasheet): a conventional half-wave patch on a standard FR4-type stack often gives only a few percent of -10 dB bandwidth; going to a low-loss, low-eps_r foam or thicker RF laminate can widen that substantially. Feeding technique also matters: a proximity or aperture-coupled feed generally offers more bandwidth than a direct edge feed, at the cost of stack complexity.
Checks before ordering a board:
1) Simulate with the real laminate eps_r and loss tangent at the operating frequency, not the 1 MHz catalogue value.
2) Include the ground plane size, the housing, and nearby components. A patch on a small device ground behaves very differently from one on an infinite ground.
3) Run a tolerance sweep on eps_r and etch width; narrow-band designs can shift out of band with normal laminate variation.
4) Measure S11 and radiation pattern in the final enclosure. A good S11 alone does not guarantee acceptable gain or pattern.
Takeaway: bandwidth is a system property of the stack-up, feed, ground and enclosure. Decide the mechanical envelope first, then choose the laminate and feed that still meet the bandwidth requirement.
