R
Member
At microwave frequencies a connector is a discontinuity, not an ideal short. Two numbers matter: how much power is dissipated (insertion loss) and how much is reflected (return loss / VSWR). A connector with modest loss but poor return loss can still wreck a measurement through multiple reflections.
Things worth checking in the datasheet and on the bench:
1) Frequency rating and interface type. Using an adapter beyond its specified range, or mixing precision and general-purpose interfaces, is a common source of damage and repeatability problems.
2) Mating cycle life and torque. A worn or under-torqued interface shows up as unstable S11 when the cable is moved. Use a torque wrench for precision connectors and keep a connector gauge for inspection.
3) Cable phase stability with flexure and temperature. Phase-sensitive systems (arrays, interferometry) care more about this than about absolute loss.
4) Cascaded mismatch: two reflections can add or cancel depending on electrical length, producing ripple in S21. If the measured trace has periodic ripple, check the spacing of the discontinuities before blaming the DUT.
Quick diagnostic order: inspect and clean the interfaces, verify with a known load, re-torque, then measure a thru with the cable flexed to see stability, and only then measure the DUT. Keep a short, well-characterised reference cable as a daily sanity check.
Takeaway: treat connectors and cables as part of the RF circuit. Log their part numbers, calibration dates and inspection status alongside the DUT data.
Things worth checking in the datasheet and on the bench:
1) Frequency rating and interface type. Using an adapter beyond its specified range, or mixing precision and general-purpose interfaces, is a common source of damage and repeatability problems.
2) Mating cycle life and torque. A worn or under-torqued interface shows up as unstable S11 when the cable is moved. Use a torque wrench for precision connectors and keep a connector gauge for inspection.
3) Cable phase stability with flexure and temperature. Phase-sensitive systems (arrays, interferometry) care more about this than about absolute loss.
4) Cascaded mismatch: two reflections can add or cancel depending on electrical length, producing ripple in S21. If the measured trace has periodic ripple, check the spacing of the discontinuities before blaming the DUT.
Quick diagnostic order: inspect and clean the interfaces, verify with a known load, re-torque, then measure a thru with the cable flexed to see stability, and only then measure the DUT. Keep a short, well-characterised reference cable as a daily sanity check.
Takeaway: treat connectors and cables as part of the RF circuit. Log their part numbers, calibration dates and inspection status alongside the DUT data.
