R
Member
The total noise factor of a cascade is
F_total = F1 + (F2 - 1)/G1 + (F3 - 1)/(G1 G2) + ...
with F and G as linear ratios, not dB. This is why the first stage's noise figure and gain matter far more than those of later stages.
Worked example: LNA with NF1 = 1.5 dB (F1 = 1.41) and G1 = 15 dB (31.6), followed by a mixer stage with NF2 = 10 dB (F2 = 10):
F_total = 1.41 + (10 - 1)/31.6 = 1.41 + 0.285 = 1.70 -> NF ~ 2.3 dB
If the LNA gain drops to 5 dB (3.16):
F_total = 1.41 + 9/3.16 = 4.26 -> NF ~ 6.3 dB
The same LNA noise figure, but the cascade degrades by 4 dB. Inserting a lossy filter before the LNA is even worse: a passive loss L has F = L and G = 1/L, so it adds directly to the system noise figure.
Practical consequences:
1) Put the narrowest acceptable filtering after sufficient gain, or accept the NF penalty explicitly.
2) Do not judge an LNA by noise figure alone. Check input match, stability factor across frequency (including out of band), and linearity (input IP3 / P1dB).
3) Simultaneous noise match and power match are rarely achievable; design for the noise match at the operating frequency and verify gain flatness.
4) Measure NF with the correct source impedance and a calibrated noise source; an unstable or oscillating LNA can give apparently excellent NF readings.
Takeaway: when a receiver NF budget blows up, check the first-stage gain and pre-LNA losses before looking for a lower-noise device.
F_total = F1 + (F2 - 1)/G1 + (F3 - 1)/(G1 G2) + ...
with F and G as linear ratios, not dB. This is why the first stage's noise figure and gain matter far more than those of later stages.
Worked example: LNA with NF1 = 1.5 dB (F1 = 1.41) and G1 = 15 dB (31.6), followed by a mixer stage with NF2 = 10 dB (F2 = 10):
F_total = 1.41 + (10 - 1)/31.6 = 1.41 + 0.285 = 1.70 -> NF ~ 2.3 dB
If the LNA gain drops to 5 dB (3.16):
F_total = 1.41 + 9/3.16 = 4.26 -> NF ~ 6.3 dB
The same LNA noise figure, but the cascade degrades by 4 dB. Inserting a lossy filter before the LNA is even worse: a passive loss L has F = L and G = 1/L, so it adds directly to the system noise figure.
Practical consequences:
1) Put the narrowest acceptable filtering after sufficient gain, or accept the NF penalty explicitly.
2) Do not judge an LNA by noise figure alone. Check input match, stability factor across frequency (including out of band), and linearity (input IP3 / P1dB).
3) Simultaneous noise match and power match are rarely achievable; design for the noise match at the operating frequency and verify gain flatness.
4) Measure NF with the correct source impedance and a calibrated noise source; an unstable or oscillating LNA can give apparently excellent NF readings.
Takeaway: when a receiver NF budget blows up, check the first-stage gain and pre-LNA losses before looking for a lower-noise device.
