R
Member
A basic link budget is an accounting exercise:
P_rx = P_tx + G_tx - L_tx - L_fs - L_misc + G_rx - L_rx
All terms in dB. EIRP = P_tx + G_tx - L_tx, i.e. what an isotropic radiator would need to emit to give the same far-field power density. Regulatory limits generally apply to EIRP, so antenna gain and cable loss are part of the compliance calculation, not an afterthought.
Free-space path loss:
L_fs(dB) = 20 log10(d) + 20 log10(f) + 32.44 (d in km, f in MHz)
At 2.4 GHz and 100 m: 20log10(0.1) + 20log10(2400) + 32.44 = -20 + 67.6 + 32.44 ~ 80 dB. Doubling the distance adds 6 dB; doubling the frequency also adds 6 dB.
Then check the receiver side: P_rx must exceed sensitivity by the required margin, and sensitivity itself depends on bandwidth, noise figure and required SNR:
Sensitivity ~ -174 dBm/Hz + 10log10(BW) + NF + SNR_req
Margins that are routinely omitted:
Fade margin for multipath and obstacle variation
Body / hand / enclosure detuning loss
Implementation loss in the modem and ageing / temperature variation
Interference margin, which is not the same as thermal-noise margin
Verification: compare the calculated budget with a conducted measurement first, then an over-the-air measurement in the real environment, and record packet error rate rather than just RSSI.
Takeaway: a link that closes with 0 dB margin on a spreadsheet will fail in the field. Budget the fade, detuning and interference terms explicitly.
P_rx = P_tx + G_tx - L_tx - L_fs - L_misc + G_rx - L_rx
All terms in dB. EIRP = P_tx + G_tx - L_tx, i.e. what an isotropic radiator would need to emit to give the same far-field power density. Regulatory limits generally apply to EIRP, so antenna gain and cable loss are part of the compliance calculation, not an afterthought.
Free-space path loss:
L_fs(dB) = 20 log10(d) + 20 log10(f) + 32.44 (d in km, f in MHz)
At 2.4 GHz and 100 m: 20log10(0.1) + 20log10(2400) + 32.44 = -20 + 67.6 + 32.44 ~ 80 dB. Doubling the distance adds 6 dB; doubling the frequency also adds 6 dB.
Then check the receiver side: P_rx must exceed sensitivity by the required margin, and sensitivity itself depends on bandwidth, noise figure and required SNR:
Sensitivity ~ -174 dBm/Hz + 10log10(BW) + NF + SNR_req
Margins that are routinely omitted:
Fade margin for multipath and obstacle variation
Body / hand / enclosure detuning loss
Implementation loss in the modem and ageing / temperature variation
Interference margin, which is not the same as thermal-noise margin
Verification: compare the calculated budget with a conducted measurement first, then an over-the-air measurement in the real environment, and record packet error rate rather than just RSSI.
Takeaway: a link that closes with 0 dB margin on a spreadsheet will fail in the field. Budget the fade, detuning and interference terms explicitly.
