FR2 beam / TCI switch transients: mid-dwell EVM is not a beam-change release gate

Started by LunaWei · 2026-11-11 01:51 UTC · 30 views · 2 replies
L Admin
[Technical article / FAQ, rfforum Editorial Team]

An FR2 UE or gNB that meets EVM and ACLR mid-dwell can still fail the first symbols after a beam or TCI switch. Phase, gain, and PLL settling on the new beam are not exercised by a "hold this beam and measure" acceptance. Traffic switches beams; a desk mid-dwell number does not.

1. What the switch actually moves
- A beam or TCI change can retune a PLL, switch front-end paths, and reshape the array excitation. Residual phase and amplitude error in the first 50–200 µs show up as EVM and spectral regrowth.
- Mid-dwell EVM after 1–2 ms of settling is a different test from the symbol that sits on the switch edge. Passing the former does not imply passing the latter.
- A codebook switch that looks fine in a conducted mid-dwell test can fail OTA when element phases are still walking, or when the product's real sequencing is slower than the lab script.

2. Freeze list before you sign FR2 EVM or ACLR with beam switching in the product
- Whether the analyzer or UE gate included the first symbols after the TCI or beam command, or only mid-dwell
- Switch time used (command-to-stable) and whether PLL and front-end sequencing were the same as the product
- Conducted versus OTA, and whether element phase residuals were logged
- Thermal and supply under the real switch duty cycle. A desk single-switch plot is not a traffic pattern.

3. Habit
Never release a beamforming FR2 radio on mid-dwell EVM alone if the product switches beams in traffic. Archive a leading-edge-gated plot next to the mid-dwell number. If only the edge fails, chase PLL, bias, or phase-command timing before you buy another PA or array. If the fail tracks the scheduled gap, document switch time as a release gate.

4. Practical ten-minute gate
- Gate EVM and ACLR on the first slot after the switch versus mid-dwell on the same beam pair
- Lengthen or shorten the scheduled gap and see whether the fail tracks the gap
- Repeat at product case temperature: a cold mid-dwell pass that fails hot after a switch is a settling problem, not a "PA ACLR" problem

Discussion: on your last FR2 EVM surprise, was it mid-dwell or the first symbols after a TCI or beam change — and do you require an edge-gated plot on every beam-switch traveler?

— rfforum 编辑部 / Editorial Team
L Admin
Addendum — FR2 beam-switch traveler: whether the gate included the first symbols after the TCI/beam command or only mid-dwell, command-to-stable time with product PLL/front-end sequencing, conducted vs OTA and any element-phase residual, and thermal/supply under the real switch duty cycle. Mid-dwell EVM alone is not a traffic-switch release gate.

Open: on your last FR2 EVM surprise, was it mid-dwell or the first symbols after the switch — and do you require an edge-gated plot?

— rfforum 编辑部 / Editorial Team
N Member
Cost-wise, this looks good on paper, but double-check the production numbers before committing.
广告 AdRenesas 瑞萨微控制器芯片产品照片Renesas Electronics微控制器、模拟与射频/时钟方案 · MCUs, analog, RF and timing访问官网 →免费展示 · 资料来自公开信息 · 如需撤下请联系 ads@rfforum.com
广告 Ad广告位招商 / Advertise hereads@rfforum.com · 刊例 Rate cardT2 · 728×90
Log in or register to reply.