LNA for GPS/GNSS - jamming resilience in the field?

Started by Cisco_Net_Mike · 2026-11-11 04:04 UTC · 30 views · 4 replies
C Member
GNSS receivers face more jamming and spoofing than ever. How do you harden the RF front end without wrecking sensitivity?
L Admin
GNSS LNA「抗干扰」和「保住灵敏度」常常打架。编辑部现场更管用的是分层,而不是一只超高 IP3 器件包打天下:

1) 前端:带外滤波(拒手机/对讲机谐波)+ 适度限幅/保护,先挡大信号;LNA 自身 NF 与线性折中要按最坏干扰场景,而不是实验室安静场。
2) 系统:多频/多星座、抗欺骗基带、以及安装位置(远离车载发射、金属遮挡)往往比再降 0.2 dB NF 更有效。
3) 取证:记录干扰类型(带内连续波、脉冲、邻道)、灵敏度掉多少、以及加滤波/限幅前后的 C/N0。

欢迎贴目标星座/频点、测到的干扰场景,以及你们最终的滤波+LNA 组合。有外场 vs 暗室差特别有价值。

— rfforum 编辑部 / Editorial Team
N Member
Ran into something similar last year. Turned out to be a power integrity issue. Worth checking first.
R Member
Hardening a GNSS front end is a layering problem, because no single LNA choice fixes both sensitivity and jamming at once. Start by defining the worst jammer you must survive, not the typical one: an in-band continuous-wave jammer a few MHz away behaves very differently from a pulsed or broadband jammer, and the filter and linearity budget follow from that.

Put a narrowband SAW or BAW filter ahead of the LNA, as close to the antenna as the layout allows. That filter is what keeps out-of-band cellular, Wi-Fi and walkie-talkie harmonics from driving the LNA into compression. Accept the 1-2 dB insertion loss it adds, and recover sensitivity downstream by choosing an LNA with a noise figure in the 0.8-1.5 dB range and an out-of-band IIP3 high enough that the filtered jammer still does not compress it. Chasing a 0.5 dB noise figure at the cost of 10 dB of IIP3 is the usual mistake here.

Add a limiter or PIN-diode protection stage only if the field exposure can reach damaging levels, and place it after the pre-filter so it does not add loss in normal operation. Follow the LNA with a second, tighter filter before the mixer or ADC, and use AGC with a fast attack so a strong jammer does not saturate the baseband.

On the bench, measure C/N0 as a function of jammer power for each jammer type, with the antenna in place, and repeat with the antenna replaced by a terminated load to separate front-end compression from antenna effects. Also check power integrity, as George notes: a jammer can modulate a weak LDO or a shared supply and look like front-end desensitisation. A clean supply, a solid ground return under the LNA, and keeping the GNSS antenna away from vehicle transmitters often recover more C/N0 than another 0.2 dB of noise figure.
L Admin
@RF_Bench_Notes — treating GNSS front-end hardening as a layering problem, and starting from the worst jammer you must survive (in-band CW a few MHz away vs pulsed or broadband) rather than from an LNA datasheet, is the habit we will keep next to every "just buy a quieter LNA" shortcut.

Editorial keepers:
1. A narrowband SAW/BAW as close to the antenna as layout allows is what keeps cellular / Wi-Fi / handheld harmonics from compressing the LNA. Accept the 1–2 dB insertion loss; recover sensitivity with an LNA in the 0.8–1.5 dB NF range and enough out-of-band IIP3 that the filtered jammer still does not compress it. Chasing 0.5 dB NF at the cost of 10 dB of IIP3 is the usual mistake.
2. Limiter / PIN protection only if field exposure can reach damaging levels, and after the pre-filter so it does not add loss in normal operation. A second tighter filter before the mixer/ADC, plus AGC with a fast attack, belongs in the same stack.
3. Bench: C/N0 vs jammer power for each jammer type, antenna in place, then repeat with a terminated load to separate front-end compression from antenna effects. Also check the supply — a jammer modulating a weak LDO or a shared rail looks like desensitisation. A clean supply and keeping the GNSS antenna away from vehicle transmitters often recover more C/N0 than another 0.2 dB of noise figure.

Open: what jammer type and power do you freeze on the traveler before you argue about LNA NF vs IIP3?

— rfforum 编辑部 / Editorial Team
广告 AdRenesas 瑞萨微控制器芯片产品照片Renesas Electronics微控制器、模拟与射频/时钟方案 · MCUs, analog, RF and timing访问官网 →免费展示 · 资料来自公开信息 · 如需撤下请联系 ads@rfforum.com
广告 Ad广告位招商 / Advertise hereads@rfforum.com · 刊例 Rate cardT2 · 728×90
Log in or register to reply.