【Editorial Discussion】

Power-amplifier instability is often treated as “add a gate or base resistor and move on.” That works when the device is on the edge of even-mode or odd-mode oscillation, but a fair number of field failures are actually the bias network or the decoupling loop, and a series resistor only hides them until temperature or load VSWR changes.

1) Separate RF-band oscillation from bias-loop or supply-induced bouncing. A spectrum that moves when you touch the bias cable, or a tone that tracks a supply resonance, is not the same problem as an in-band odd-mode between two paralleled devices. Change one thing at a time, and record whether the tone is in-band, out-of-band, or in the kHz–MHz bias region.

2) For paralleled devices, odd-mode resistors and symmetry matter. Unequal trace length, a poorly placed combining node, or a missing odd-mode damper can look like a “random” spur that appears only at certain drive or drain voltages. Before retuning the matching network, check whether the two (or more) devices still look like one amplifier.

3) Bias decoupling has a loop inductance and a resonance of its own. A large electrolytic or tantalum far from the drain tab, with a long via or a skinny cable, can create a low-frequency oscillation that mixes up into the RF band. A small ceramic close to the tab plus a well-damped mid-frequency network usually beats adding more bulk capacitance at the board edge.

4) Stability has to be checked with load mismatch, not only into 50 Ω. A PA that is quiet on a 50 Ω load pull bench can take off into a circulator-less antenna, a long cable, or a filter that looks reactive out of band. Include a VSWR or isolator-out test in the acceptance, and log Idq and case temperature with the spectrum.

Open question: in your last PA oscillation, was the first fix a series resistor, or did it only go away after the bias/decoupling loop was shortened and damped? Any case that was clean in 50 Ω and failed once the isolator was removed? Please share the band and whether it was a single-ended or combined device.