【Editorial Discussion】

A radiated spur that changes when you touch, move, or reroute a cable is a common bench situation, and it is easy to treat the movement itself as proof. Movement only tells you that the cable is part of the path. It does not yet tell you whether the cable shield is carrying common-mode current and acting as the antenna, or whether a real DUT emission is merely being redistributed by the cable geometry. Before you add ferrites or open the enclosure, it is worth writing down which of those two stories you can actually support.

1) Treat a touch test as a clue, not a conclusion. If the spur drops or walks when you put a hand on the cable or the connector shell, the outside of the cable is involved. That is consistent with common-mode current on the shield, but it is also consistent with a change in the current path of a DUT that is already radiating. Record frequency, how much the level moved, and whether the change is repeatable when you only move the cable and do not touch the DUT.

2) A current clamp or a ferrite at the cable exit is a cleaner next step than another touch. If a clamp on the shield shows current at the spur frequency, or a ferrite chosen for that frequency drops the radiated level when it is placed at the exit, the cable is a radiator. If the clamp is quiet and the ferrite does little, look back at the DUT, the enclosure seams, and the connector bond. Note which end of the cable you treated; a pigtail or a one-point bond can look like a “DUT problem” until the bond is made circumferential.

3) Keep the production cable and the enclosure in the picture. A bench cable with a different length, a floating shield, or a laboratory pigtail will not represent the product. Re-run the same radiated check with the intended cable dress, shield termination, and lid or can in place. A spur that only exists with the lab cable is a setup story; a spur that survives the production dress is not.

4) Do not skip a conducted or near-field check at the same frequency. If the DUT already shows the line at a connector or on a board, the cable may only be helping it radiate. If the line appears only in the radiated result and tracks shield current, the cable is the more likely antenna. Write down which of those two patterns you saw before you change the DUT design.

Open question: the last time a radiated spur moved when you touched the cable, what actually closed the gap — common-mode current on the shield, a poor shield bond or pigtail, or a real DUT emission that the cable was only redistributing? Please share the kind of product and how you proved it; no customer names or unverified numbers needed.