【Editorial】Antenna phase center that walks with frequency: do you treat it as a mechanical point, or as a frequency-dependent correction?

Started by OfficialEditorRF · 2026-11-15 02:02 UTC · 21 views · 1 replies
O Member
【Editorial Discussion】

A single mechanical point — a connector, a flange, a marked “phase centre” on a drawing — is a convenient reference, but it is not always where the radiated phase actually comes from. On a wideband antenna the apparent phase centre can walk with frequency as the active region moves. If a ranging, array, or gain-transfer calculation treats that walk as a fixed point, the error is easy to blame on the chamber, the cable, or the AUT mount. Before you do that, it is worth writing down whether you measured the walk, and whether your reduction actually used a frequency-dependent correction.

1) Say what “phase centre” means in the note. For a given cut and polarisation, it is the apparent origin that makes the far-field phase versus angle as flat as you need, or the delay origin that makes range or path-length consistent. It is not automatically the connector, the aperture, or a single CAD point. If the last campaign used a mechanical mark at every frequency, write that down; it is a different assumption from a centre fitted at each frequency.

2) Wideband antennas are the usual place this matters. A Vivaldi, an LPDA, a horn with a noticeable flare, or a loaded element can have an active region that moves along the structure as frequency changes. A narrowband patch may barely walk over its match bandwidth; a multi-octave feed often will. A phase-versus-frequency trace, or a repeated bore-sight delay measurement against a known-stable reference, will show the walk. If that trace is sloped or has steps, a single mechanical point will not serve every frequency in the same campaign.

3) The correction has to be used, not only measured. Array calibration, compact-range or substitution gain, and ranging or interferometric work all turn a path length into a result. If you measured a walk and then still reduced every frequency to the same mechanical mark, the walk is still in the data. Apply a frequency-specific path or delay correction, or state clearly that the campaign treated the centre as fixed and what residual that implies.

4) Do not confuse phase-centre walk with a cable, a mount, or a chamber ripple. Flexing the cable, rotating the AUT on a poorly centred mount, or a standing-wave in the chamber can also move phase. A leave-it-connected repeat, a remount at the same frequency, and a walk that is smooth and repeatable across frequency help separate a real antenna term from a setup term. Record polarisation, cut, and which mechanical point you started from.

Open question: the last time a phase or range result walked with frequency, what actually closed the gap — a frequency-dependent phase-centre correction, a mechanical point that was good enough over that band, or a cable / mount / chamber term that had been mistaken for the antenna? Please share the kind of antenna and how you proved it; no customer names or unverified numbers needed.
N Member
We've hit this exact pitfall. Ended up switching vendors - sometimes it's a supply issue, not a design issue.
广告 AdRenesas 瑞萨微控制器芯片产品照片Renesas Electronics微控制器、模拟与射频/时钟方案 · MCUs, analog, RF and timing访问官网 →免费展示 · 资料来自公开信息 · 如需撤下请联系 ads@rfforum.com
广告 Ad广告位招商 / Advertise hereads@rfforum.com · 刊例 Rate cardT2 · 728×90
Log in or register to reply.