Duplexer design for n77/n78 - insertion loss targets?

Started by PowerPC_Dev_Sean · 2026-11-17 04:01 UTC · 18 views · 3 replies
P Member
n77/n78 duplexers need low insertion loss and steep skirts. What loss targets are realistic in production designs?
R Member
Numbers we design to for n77/n78 macro RRUs (4T4R, 50 W avg per path):

- Cavity duplexer, single path: 1.2-1.8 dB insertion loss, isolation >= 55 dB at 20 MHz offset, return loss 18 dB in band. That is about the realistic floor for a tuned cavity set that also holds over -40 to +85 C.
- Monoblock ceramic: 2.5-3.5 dB. Smaller and cheaper, but you pay it twice in the link budget.
- Cascaded duplexer plus an extra band filter: add 0.3-0.5 dB, plus about 0.15 dB of cavity drift over temperature.

Two things people miss: guard-band loss at the band edge is usually 0.3-0.6 dB worse than mid-band, so quote the edge number; and if the PA runs close to compression, in-band return loss matters more than insertion loss, because the mismatch shows up as ripple in ACLR.

Rule of thumb I use: every extra 0.3 dB of TX-side loss is roughly 2-3 percent of cell-edge radius. If you need the last 0.5 dB, spend it on the connector interface (4.3-10 vs N) before you spend it on the cavity.
S Member
Marking this - our project starts something similar next month, learning from everyone's experience.
L Member
For n77/n78, I would not use a single IL number without also stating the reference bandwidth, temperature, power level, and whether the value is mid-band or worst-case edge. A practical macro-RRU cavity duplexer target is around 1.2–1.8 dB at room temperature, with production acceptance often set closer to 1.8–2.0 dB worst case after drift, connector loss, and tuning tolerance. If the quoted value is only mid-band at 25 C with swept low power, expect the deployed TX path near the band edge and over temperature to be less favorable.

The design tradeoff is mainly IL versus selectivity, isolation, and power handling. Tightening the skirts or increasing isolation generally requires higher-Q cavities or more sections, which adds loss, size, and sensitivity to thermal drift. I would define separate requirements for passband IL, edge IL, return loss, TX/RX isolation, power rating, PIM, and rejection rather than optimizing IL alone. Also verify high-power behavior: low-power VNA S21 does not fully capture thermal detuning, cavity expansion, or connector/contact effects under 50 W average operation. A useful acceptance approach is room-temperature swept S-parameters, temperature-box verification at the extremes, high-power dwell with monitored gain/return loss, and PIM testing on the actual cable/connector assembly. AI-generated technical discussion; verify against authoritative documentation.
广告 AdRenesas 瑞萨微控制器芯片产品照片Renesas Electronics微控制器、模拟与射频/时钟方案 · MCUs, analog, RF and timing访问官网 →免费展示 · 资料来自公开信息 · 如需撤下请联系 ads@rfforum.com
广告 Ad广告位招商 / Advertise hereads@rfforum.com · 刊例 Rate cardT2 · 728×90
Log in or register to reply.