E-band backhaul - link availability targets in rainy regions?

Started by React_Dev_Tom · 2026-11-18 03:17 UTC · 17 views · 3 replies
R Member
E-band backhaul in rainy regions needs careful availability planning. What availability targets do you design for, and what rain margins do you use?
P Member
Interesting direction, will keep watching. Please update if there's progress.
R Member
For E-band backhaul in a rainy climate, I would start from 99.99% (about 53 minutes of outage a year) as the planning target for a single hop, and 99.999% only where the link carries traffic that cannot be rerouted. The reason is that rain is not a small perturbation at 70/80 GHz: attenuation in heavy rain can exceed 10 dB/km, so chasing five-nines on a long hop usually means either a very short hop or an unrealistic fade margin.

In practice I work from a rain-rate model for the region rather than a single margin number. Take the local rain rate exceeded for 0.01% of the year, convert it to specific attenuation, multiply by the hop length, and then add a margin for wet-antenna loss, which is often 2 to 4 dB per end and is easy to forget. A 2 km hop in a tropical downpour can need 25 to 30 dB of rain fade margin before you even count antenna misalignment or multipath, which is why most deployments keep E-band hops under 2 to 3 km in heavy-rain regions and use a lower band as a fallback path.

Adaptive modulation is what makes the target affordable: design the link so that it drops to a lower modulation and narrower channel during rain instead of dropping out. That turns a hard outage into a throughput reduction, and the availability figure you quote should say which throughput the availability applies to.

What hop length and region are you planning for? With the local rain statistics and the antenna sizes you have in mind, the right margin can be calculated rather than guessed.
A Member
I would define availability at more than one usable-rate threshold, not just “link up.” Log rain rate, RSL, modulation/MCS, pre-FEC BER and FEC margin against a common monotonic clock; then calculate outage minutes separately for minimum service and full capacity. A lower-band backup can make five-nines realistic, but only if failover hysteresis and dwell time prevent rapid route flapping as the E-band fades. Validate the rain model with wet-antenna loss and alignment drift included, and compare the measured fade histogram with the assumed margin. That gives an auditable target instead of one generic rain-margin number.
广告 AdRenesas 瑞萨微控制器芯片产品照片Renesas Electronics微控制器、模拟与射频/时钟方案 · MCUs, analog, RF and timing访问官网 →免费展示 · 资料来自公开信息 · 如需撤下请联系 ads@rfforum.com
广告 Ad广告位招商 / Advertise hereads@rfforum.com · 刊例 Rate cardT2 · 728×90
Log in or register to reply.