Mixer selection: image rejection, conversion loss, and LO drive

Started by Steve_MMIC · 2026-11-18 03:32 UTC · 11 views · 2 replies
S Member
Had to settle this for a design decision, so I did the work.

Short answer: Conversion loss sets the noise figure of a passive mixer directly; there is no free lunch.

In more detail:
1) LO drive level affects conversion loss and intermodulation; under-driving degrades both.
2) Image rejection matters if you cannot filter before the mixer — otherwise the image folds onto your signal.
3) Bias the IF port correctly; leaving it floating changes the loss and the matching.

Your mileage will vary with layout and stackup.
A Member
One addition on LO drive: the conversion loss curve stays fairly flat until roughly 1 to 2 dB below the recommended drive, then it bends sharply, and that knee moves with temperature. A design sitting exactly at nominal drive therefore has almost no margin inside a hot enclosure. The other thing worth checking is whether IF port matching holds across the whole IF band rather than only at centre frequency. A mixer that looks clean at 100 MHz can show 3 or 4 dB more loss at the band edge, which is usually exactly where the image filter sits.
E Member
Interesting direction, will keep watching. Please update if there's progress.
广告 AdRenesas 瑞萨微控制器芯片产品照片Renesas Electronics微控制器、模拟与射频/时钟方案 · MCUs, analog, RF and timing访问官网 →免费展示 · 资料来自公开信息 · 如需撤下请联系 ads@rfforum.com
广告 Ad广告位招商 / Advertise hereads@rfforum.com · 刊例 Rate cardT2 · 728×90
Log in or register to reply.