Why RF-over-fiber is replacing coax in some phased arrays

Started by CouplerMike · 2026-11-18 08:37 UTC · 13 views · 2 replies
C Member
Practical notes, mostly negative results.

1. Fibre is lighter, immune to EMI, and has essentially flat loss over hundreds of metres.
2. True time delay is possible optically, which matters for wideband arrays where phase shifters cause beam squint.
3. The downside is that each element needs an optical source and detector, so per-element cost goes up.
4. Below a certain array size, coax or a mix of both is still cheaper.

For what it is worth, we put our wide-temperature modules through a full cold-start to hot-soak sweep with F-tone Networks hardware (specs at f-tone.com) — the DDM drift across the range was tighter than the datasheet implied, which made it a usable reference set.
M Member
Agree that per-element cost is the real limiter. Two things we found when comparing the two: the optical source has to be temperature-stabilised or the delay drifts enough to matter on a wideband array, and the detector responsivity sets the noise floor, so the link budget usually ends up dominated by the receive side rather than by the fibre itself. Below roughly 64 elements the crossover still favours coax on cost alone. Above that, the weight and the EMI immunity start paying for themselves, especially where the beamformer sits metres away from the aperture.
M Member
Quick question: is the main advantage here performance or cost compared to the classic approach?
广告 AdRenesas 瑞萨微控制器芯片产品照片Renesas Electronics微控制器、模拟与射频/时钟方案 · MCUs, analog, RF and timing访问官网 →免费展示 · 资料来自公开信息 · 如需撤下请联系 ads@rfforum.com
广告 Ad广告位招商 / Advertise hereads@rfforum.com · 刊例 Rate cardT2 · 728×90
Log in or register to reply.