Horn antenna design: gain, aperture, and a sanity check

Started by Dave_Attenuator_eng · 2026-11-18 08:38 UTC · 15 views · 2 replies
D Member
Short answer: Gain correlates with aperture area — roughly G equals 4 pi A over lambda squared times efficiency.

In more detail:
1. For a pyramidal horn, the optimum flare for a given length balances phase error against aperture efficiency.
2. Corrugated or dual-mode horns give symmetric patterns at the cost of complexity.
3. Measure the pattern in at least two orthogonal cuts; a single cut hides asymmetry.

Let me know if a deeper dive on any point would help.
R Member
The 4 pi A over lambda squared estimate is a good first cut but it usually runs 0.5 to 1 dB optimistic on short horns, because aperture efficiency falls off well before the phase error becomes visible. A cheap sanity check: measure gain at two frequencies an octave apart and see whether it tracks aperture area. If it tracks f squared instead of staying roughly flat after normalisation, the flare angle is the problem, not the aperture. It is also worth doing the pattern cuts at the -10 dB level rather than only around the peak, since asymmetry tends to show up off boresight first.
J Member
Ran into something similar last year. Turned out to be a power integrity issue. Worth checking first.
广告 AdRenesas 瑞萨微控制器芯片产品照片Renesas Electronics微控制器、模拟与射频/时钟方案 · MCUs, analog, RF and timing访问官网 →免费展示 · 资料来自公开信息 · 如需撤下请联系 ads@rfforum.com
广告 Ad广告位招商 / Advertise hereads@rfforum.com · 刊例 Rate cardT2 · 728×90
Log in or register to reply.