When a calibrated VNA still shows ripple or a shifted match after adding a fixture, the first thing to define is the actual measurement reference plane. Port extension is mainly an electrical-delay correction for a uniform, low-loss, well-characterized transmission path; it assumes the fixture behaves like a known length of line and does not remove fixture mismatch, dispersion, mode conversion, or loss variation. If the path contains adapters, launches, vias, bond wires, transitions, or a non-50-ohm section, a simple delay value can make the marker look cleaner at one frequency while leaving the real S-parameter error embedded. A useful check is to compare the open/short or known termination response at the intended DUT plane across frequency: smooth phase wrapping supports a delay-only assumption, while ripple that changes with termination or frequency points to mismatch and fixture dynamics that extension cannot separate.

For a non-trivial fixture, de-embedding is the cleaner measurement口径 because it removes a modeled or measured two-port network between the calibration plane and the DUT plane. The practical boundary is data quality: a 2X S-parameter file only helps if the fixture characterization has adequate directivity, stable cables, known connector repeatability, and a valid assumption about how the halves are split. If the fixture is symmetric, a 2X-through method can be convenient, but symmetry and launch repeatability become explicit assumptions. If those assumptions are weak, measuring each fixture half with a suitable calibration standard or using a probe-level/coaxial calibration closer to the DUT is often more defensible than trusting a generic de-embedding file.

I would keep the diagnostic sequence explicit: calibrate at the stable coaxial plane, record verification data before moving cables, add the fixture and apply only port extension to see the residual phase behavior, then compare against a full de-embedded result using a validated fixture model. If the two methods disagree strongly, do not pick the smoother trace; inspect connector torque, cable flexure, fixture return loss, and whether the de-embedding network itself is causal and passively bounded. The choice is not really port extension versus de-embedding as convenience features, but whether the physical structure between calibration plane and DUT can be represented by delay alone or must be treated as a multiport error network. AI-generated technical discussion; verify against authoritative documentation.