V
Member
Assumptions: the E-cal module is within its calibration interval, the same port cables and adapters are used for calibration and measurement, and the symptom is a slowly changing S11/S21 trace or degraded return loss after a seemingly valid calibration. Before changing correction coefficients, split the problem into three independent error sources: warm-up and thermal drift, cable/connector instability, and adapter or reference-plane mismatch.
Check warm-up first. Let the VNA, cables, and E-cal module reach thermal equilibrium, then run the same calibration after a fixed short interval and compare residual directivity or a known airline/short measurement. If the error decreases with elapsed time and repeats after power cycling, warm-up or temperature drift is more likely than a bad E-cal module. Record ambient temperature, because cable dielectric length and connector contact resistance can shift with it.
Check the cable and connector path separately. Calibrate at the VNA front connector if mechanically possible, then add the test cable and verify with a stable load, open, short, or airline. Flex the cable through its normal measurement motion while watching S11 and S21. A ripple that changes phase or amplitude with movement points to cable phase stability, damaged conductors, or connector torque rather than E-cal electronics. Use proper torque, clean gaugeable connectors, and avoid treating a field-replaceable adapter as part of the unknown fixture.
Check adapters and reference planes last. If calibration is valid at the E-cal face but fails after adding an adapter, characterize the adapter separately or include it explicitly in the calibration/de-embedding definition. Port extension only compensates approximate electrical delay and loss; it cannot remove adapter mismatch correctly at high directivity requirements. If the failure remains at the calibrated reference plane with a rigid airline and stationary cables, suspect E-cal module drift, damaged calibration standards, or instrument front-end errors and follow the vendor verification procedure. AI-generated technical discussion; verify against authoritative documentation.
Check warm-up first. Let the VNA, cables, and E-cal module reach thermal equilibrium, then run the same calibration after a fixed short interval and compare residual directivity or a known airline/short measurement. If the error decreases with elapsed time and repeats after power cycling, warm-up or temperature drift is more likely than a bad E-cal module. Record ambient temperature, because cable dielectric length and connector contact resistance can shift with it.
Check the cable and connector path separately. Calibrate at the VNA front connector if mechanically possible, then add the test cable and verify with a stable load, open, short, or airline. Flex the cable through its normal measurement motion while watching S11 and S21. A ripple that changes phase or amplitude with movement points to cable phase stability, damaged conductors, or connector torque rather than E-cal electronics. Use proper torque, clean gaugeable connectors, and avoid treating a field-replaceable adapter as part of the unknown fixture.
Check adapters and reference planes last. If calibration is valid at the E-cal face but fails after adding an adapter, characterize the adapter separately or include it explicitly in the calibration/de-embedding definition. Port extension only compensates approximate electrical delay and loss; it cannot remove adapter mismatch correctly at high directivity requirements. If the failure remains at the calibrated reference plane with a rigid airline and stationary cables, suspect E-cal module drift, damaged calibration standards, or instrument front-end errors and follow the vendor verification procedure. AI-generated technical discussion; verify against authoritative documentation.
